Pengo Computer Accessories uBR7200 User Manual download pdf (Page 34)

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

pppoe tag

Cisco IOS Release 12.1(5)XM

pppoe tag

To assign a qos-level tag for packet from a particular SU so that the packet is forwarded to a particular

virtual circuit, use the tag global configuration command. To disable the tag specification, use the no

form of this command.

tag string qos-level level-num type {pppoe | all [sid-index]}

no tag string qos-level level-num type {pppoe | all [sid-index]}

Syntax Description

Defaults No default behaviors or values.

Command Modes Global configuration

Command History

Examples In the following example, all PPPoE packets arriving from an SU previously registered with SU tag

“UunNet-Gold" are assigned qos-level 1:

Router(config)# tag UUNet-Gold qos_level 1 type pppoe

Related Commands

String Specifies the tag name to be used.

qos-level level-num Specifies QoS level number to map to a virtual circuit (VC). The range for

level-num is 1 to 1024.

type {pppoe | all} Specifies packet fowarding options as either pppoe or all.

pppoe Specifies that only pppoe packets are allowed to forwarding.

all Specifies that all packets are allowed to forwarding.

sid-index Creates service identifier index in an internal table.

Release Modification

12.1(3)XQ1 This command was introduced.

Command Description

pppoe-forwarding Enable PPPoE forwarding on the radio interface.

forwarding

default-qos-level

Set all packets received on the radio interface with a single

quality-of-service (QoS)-level.

forwarding group Sets a PPPoE forwarding group number on the radio interface.

su-mac Specifies the subscriber unit MAC address that is mapped from the radio

interface to the virtual circuit (VC) on the ATM interface for PPPoE

forwarding.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 179 180

No comments

Pengo Computer Accessories uBR7200 User Manual Page 34